An arduino library to communicate using the Dallas one-wire protocol, where the Arduino takes the role of a slave.
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

88 lines
2.6 KiB

#include "Arduino.h"
#include "SerialChannel.h"
#define LEDPin 13
#define OWPin 2
#define InterruptNumber 0 // Must correspond to the OWPin to correctly detect state changes. On Arduino Uno, interrupt 0 is for digital pin 2
const int SkipSamples = 8; // how many samples we want to skip between two samples we keep (can be used to lower the sampling frequency)
const int BufferSize = 128;
byte buffer1[BufferSize];
byte buffer2[BufferSize];
byte* backBuffer = buffer1;
byte backBufferPos = 0;
byte samplesSkipped = SkipSamples;
unsigned long backBufferStartTime = micros();
SerialChannel oscilloscope("oscilloscope");
SerialChannel debug("debug");
void setup()
{
pinMode(LEDPin, OUTPUT);
pinMode(OWPin, INPUT);
digitalWrite(LEDPin, LOW);
attachInterrupt(InterruptNumber,onewireInterrupt,CHANGE);
cli();//disable interrupts
//set up continuous sampling of analog pin 0
//clear ADCSRA and ADCSRB registers
ADCSRA = 0;
ADCSRB = 0;
ADMUX |= (1 << REFS0); //set reference voltage
ADMUX |= (1 << ADLAR); //left align the ADC value- so we can read highest 8 bits from ADCH register only
ADCSRA |= (1 << ADPS2) | (1 << ADPS1) | (1 << ADPS0); //set ADC clock with 128 prescaler- 16mHz/128=125kHz ; 13 cycles for a conversion which means 9600 samples per second
ADCSRA |= (1 << ADATE); //enabble auto trigger
ADCSRA |= (1 << ADIE); //enable interrupts when measurement complete
ADCSRA |= (1 << ADEN); //enable ADC
ADCSRA |= (1 << ADSC); //start ADC measurements
sei();//enable interrupts
Serial.begin(9600);
}
void loop()
{
cli();//disable interrupts
byte* currentBuffer = backBuffer;
unsigned long currentBufferStartTime = backBufferStartTime;
byte currentBufferSize = backBufferPos;
backBuffer = (backBuffer == buffer1 ? buffer2 : buffer1);
backBufferPos = 0;
backBufferStartTime = micros();
sei();//enable interrupts
debug.write("Starting buffer transmission");
oscilloscope.write(currentBuffer, currentBufferSize, currentBufferStartTime);
debug.write("Buffer transmitted");
}
ISR(ADC_vect) {//when new ADC value ready
byte sample = ADCH; //store 8 bit value from analog pin 0
if(samplesSkipped++ < SkipSamples)
return;
samplesSkipped = 0;
backBuffer[backBufferPos++] = sample;
if(backBufferPos >= BufferSize)
{
// overflow of back buffer, we loose the current sample
backBufferPos = BufferSize - 1;
}
}
void onewireInterrupt(void)
{
//digitalWrite(LEDPin, digitalRead(OWPin));
}